63
LOGO! manual
EWA 4NEB 712 6006-02
Result: LOGO! copies the program from the program module/card to
LOGO!. While LOGO! is copying, a ’#’ flashes on the display. As soon as
LOGO! has finished copying, LOGO! displays the main menu:
>Program..
PC/Card..
Start
Now you can switch LOGO! to RUN:
Note
Before you switch LOGO! to RUN, you must ensure that the system you
are controlling with LOGO! does not represent a source of danger.
1. Move the ’>’ to Start: 2
2. Press OK
Using the PC/Card menu to copy
Read the note about changing the program module/card.
To copy a program from the program module/card to LOGO!, proceed as
follows:
1. Insert the program module/card
2. Switch LOGO! to programming mode:
, and OK simultaneously
>Program..
PC/Card..
Start
3. Move the ’>’ to ”PC/Card”:
Programming LOGO!
To Next Page
Loading...
