65
LOGO! manual
EWA 4NEB 712 6006-02
3.13Connecting LOGO! to a PC
To connect LOGO! to a PC, you need the LOGO! PC cable.
Remove the cover or the program module/card, and connect the cable
there.
Switch LOGO! to PCLOGO mode
So that the PC can access LOGO!, LOGO! must be in PC LOGO mode.
To switch LOGO! to PC LOGO mode:
1. Switch LOGO! to programming mode:
, and OK simultaneously
2. Select ’PC/Card’: or
3. Press OK
4. Select PC LOGO: or
5. Press OK
LOGO! is now in PC LOGO mode, and the following appears on the
display:
PC LOGO
STOP:
Press ESC
The PC can now access LOGO!.
To break the link to the PC, you press ESC.
Switching LOGO! to PCLOGO mode at startup
1. Switch the power off
2. Remove the cover or the program module/card, and connect the cable
there.
3. Switch the power on
LOGO! goes into PC LOGO mode automatically
Programming LOGO!
To Next Page
Loading...
