9
LOGO! manual
EWA 4NEB 712 6006-02
LOGO! 24
The outputs of LOGO! 24 are switched by means of transistors. The out-
puts are short circuit-proof and overload-proof. A separate voltage supply
to the load is not necessary; LOGO! 24 supplies the load with voltage.
Requirements for transistor outputs
The load connected to LOGO! 24 must have the following properties:
S The maximum switched current is 0.3 amperes.
S When switched on (Q = 1), the maximum current is 0.3 amperes.
Connecting
You connect the load to LOGO! 24 as follows:
Load
24 V DC, 0,3 A (max.)
Installing and wiring LOGO!
To Next Page
Loading...
