LOGO! manual
EWA 4NEB 712 6006-02
54
LOGO! displays the parameter window for parameters:
B02: the parameter of block B02
T: is a time
The parameter is displayed in parame-
terization mode and can be modified
there
B02:T
T=00.00s+
Time value
Time unit
The cursor appears on the first position of the time value.
To change the time value, proceed as follows:
Use the keys and to move the cursor to the different positions.
Use the keys and to change the value.
If you have entered the time value, press the OK key.
Set the time to 12:00 minutes (T = 12:00):
1. Move the cursor to the first position: or
2. Select ’1’: or
3. Move the cursor to the second position: or
4. Select ’2’: or
5. Move the cursor to the unit: or
6. Select the unit m for minutes: or
Displaying/hiding a parameter
If you do not want the parameter to be displayed in parameterization
mode:
7. Move the cursor to the protection mode: or
8. Select the protection mode ’–’: or
You should now see the following on the display:
B02:T
T=12:00m+
B02:T
T=12:00m–
or
9. Conclude your input: OK
Programming LOGO!
To Next Page
Loading...
