Siemens LOGO! Series - Page 102

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
102 Manual, 04/2011, A5E03556174-01
In our example we do not use the reset input of the off-delay function, and we identify it with
an 'x' connector.
4
3DU
[
%
%
7KLVLVZKDWWKHGLVSOD\VKRXOGQRZVKRZ
Assigning block parameters
Now you set the off-delay time T:
1. Move the cursor to Par, if it not already at this position: Press
or
2. Switch to editing mode: Press OK
LOGO! shows the parameters in the parameter assignment window:
7 V
%5
7LPHYDOXH 7LPHEDVH
ಯರPHDQV7KHSDUDPHWHULVVKRZQ
DQGFDQEHPRGLILHGLQWKHSDUDPHWHU
DVVLJQPHQWPRGH
ಯ5ರPHDQV5HWHQWLYLW\LVHQDEOHGIRU
WKLVEORFN
77KHEORFN
SDUDPHWHU%LVD
WLPHIXQFWLRQ
To change the time value:
● Press
and to position the cursor.
● Press
and to modify the value at the relevant position.
● Confirm your entries with OK.
Setting the time
Set the time T = 12:00 minutes:
1. Move the cursor to the first digit: Press
or
2. Select the digit '1': Press
or
3. Shift the cursor to the second digit: Press
or
4. Select digit '2': Press
or
5. Move the cursor to the unit: Press
or
6. Select the timebase 'm' (for minutes): Press
or