Siemens LOGO! Series - Table of Contents

LOGO!
Manual, 04/2011, A5E03556174-01
9
Table of contents
Preface ...................................................................................................................................................... 3
1 Getting started with LOGO!...................................
................................................................................... 13
2 LOGO! install
ation and wiring .................................................................................................................. 29
2.1 Modular LOGO! setup
..................................................................................................................32
2.1.1 Max
imum LOGO! network setup (0BA7 only)..............................................................................32
2.1.2 Maxim
um setup with expansion and communication modules....................................................34
2.1.3 Setup with different voltage c
lasses ............................................................................................36
2.1.4 Compatibility...........................................................................................................
......................38
2.2 Ins
talling/removing LOGO!...........................................................................................................39
2.2.1 DIN rail mounting
.........................................................................................................................40
2.2.2 Wall-mounting
..............................................................................................................................43
2.2.3 Mounting the
LOGO! TD..............................................................................................................45
2.2.4 Labeling LOGO!
...........................................................................................................................45
2.3 Wiring LOGO!
...............................................................................................................................46
2.3.1 Connec
ting the power supply.......................................................................................................46
2.3.2 Connec
ting the LOGO! TD power supply ....................................................................................48
2.3.3 Connecting LOGO! input
s............................................................................................................49
2.3.4 Connec
ting outputs ......................................................................................................................56
2.3.5 Connec
ting the EIB bus ...............................................................................................................58
2.3.6 Connec
ting the AS interface bus .................................................................................................59
2.3.7 Connecting
modems (0BA6 only) ................................................................................................61
2.3.8 Connec
ting the Ethernet interface (0BA7 only) ...........................................................................62
2.4 Putting into operation
...................................................................................................................63
2.4.1 Switc
hing the LOGO!/Power On ..................................................................................................63
2.4.2 Putting a CM EIB/KNX into operation
..........................................................................................66
2.4.3 Operating s
tates...........................................................................................................................67
3 Programming
LOGO!............................................................................................................................... 69
3.1 Connec
tors...................................................................................................................................70
3.2 EIB inputs/outputs
........................................................................................................................73
3.3 Bloc
ks and block numbers ...........................................................................................................74
3.4 From
circuit diagram to LOGO! program .....................................................................................76
3.5 The four golden rules
for operating LOGO! .................................................................................79
3.6 Ov
erview of LOGO! menus..........................................................................................................81
3.7 Writing and s
tarting the circuit program .......................................................................................83
3.7.1 Selec
ting programming mode......................................................................................................83
3.7.2 The firs
t circuit program ...............................................................................................................85
3.7.3 Circuit program input
....................................................................................................................86
3.7.4 As
signing a circuit program name................................................................................................90
3.7.5 Pas
sword for circuit program protection ......................................................................................91