Siemens LOGO! Series - DIN Rail Mounting

LOGO! installation and wiring
2.2 Installing/removing LOGO!
LOGO!
40 Manual, 04/2011, A5E03556174-01
2.2.1 DIN rail mounting
Mounting
How to mount a LOGO! Base Module and a digital module onto a DIN rail:
1. Hook the LOGO! Base Module onto the rail.
2. Push down the lower end to snap it on. The mounting interlock at the rear must engage.
/2*2%$
/2*2%$












3. On the right side of the LOGO! Base Module/LOGO! expansion module, remove the
connector cap.
4. Place the digital module onto the DIN rail on the right-hand side of the LOGO! Base
Module.