Siemens LOGO! Series - Correcting Programming Errors; Selecting Analog Output Values for RUN;STOP Transition

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
Manual, 04/2011, A5E03556174-01
107
3.7.10 Correcting programming errors
Programming errors can be corrected easily in LOGO!:
● Provided editing mode is not yet closed, you can revert by one step by pressing E
SC.
● If you have already configured all inputs, simply reconfigure the faulty input:
1. Move the cursor to the faulty position
2. Change to editing mode. Press O
K
3. Enter the correct input circuit
You can only replace a block with a block that has exactly the same number of inputs.
However, you can delete the old block and then insert a new one. You can choose any new
block.
3.7.11 Selecting analog output values for RUN/STOP transition
You can select the analog values that are output at the two analog outputs when LOGO!
changes from RUN mode to STOP mode.
In the programming menu:

0VJ&RQILJ
3DVVZRUG
&OHDU3UJ
!(GLW
1. Move the ">" cursor to "
①": Press or
2. Select "
①": Press OK
3. Move the ">" cursor to 'A
Q': Press
or
4. Select "A
Q": Press OK
5. Move the ">" cursor to "
②": Press or

$47\SH
!$4LQ6WRS