Siemens LOGO! Series - Switching LOGO! to RUN Mode

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
Manual, 04/2011, A5E03556174-01
97
3.7.6 Switching LOGO! to RUN mode
In the main menu, select RUN to start LOGO!.

!6WDUW
6HWXS
&DUG
3URJUDP
1. Return to the main menu: Press E
SC
2. Move the '>' cursor to "
①": Press or
3. Confirm "
①": Press OK
LOGO! runs the circuit program and shows the following display:



$,



,



$,

0R


4
ႧႱ
ႧႱ
ႧႱ
ႧႱ
'LVSOD\ILHOGRI/2*2LQ581PRGH
6WDUWVFUHHQ'DWHDQGFXUUHQWWLPHRIGD\RQO\IRUYHUVLRQVZLWK
UHDOWLPHFORFN7KLVHOHPHQWIODVKHVLIWKHGDWHDQGWLPHDUHQRWVHW
2U'LJLWDOLQSXWVVHH6HFWLRQ
2U3DUDPHWHUDVVLJQPHQWPHQX7KLVVWDUWVFUHHQFRQILJXUDWLRQLV
RQO\DYDLODEOHRQ/2*2%$6HH6HFWLRQ
,QSXWV,WR,
,QSXWV,WR,
,QSXWV,WR,
2XWSXWV4WR4
2XWSXWV4WR4
$QDORJLQSXWV$,WR$,
$QDORJLQSXWV$,WR$,
3UHVV
3UHVV
3UHVV
3UHVV