Siemens LOGO! Series - Deleting the Circuit Program and Password

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
110 Manual, 04/2011, A5E03556174-01
3.7.13 Deleting the circuit program and password
To delete a circuit program and the password if one is defined:
1. Switch the LOGO! to programming mode (main menu). LOGO! opens the main menu:
L
OGO! 0BA6 main menu:

6WDUW
6HWXS
&DUG
!3URJUDP
L
OGO! 0BA7 main menu:
ႣႭ

6WDUW
!1HWZRUN
'LDJQRVWLF
6HWXS
&DUG
!3URJUDP
1. On the main menu, press
or to move the '>' cursor to "①". Press OK. LOGO! opens
the programming menu.
2. On the programming menu, move the '>' cursor to "
②": Press or

0VJ&RQILJ
3DVVZRUG
!&OHDU3UJ
(GLW
3. Confirm "
②": Press OK
<HV
!1R
&OHDU3UJ
To cancel deletion of the circuit program, leave the '>' cursor at 'N
o' and press OK.
If you are sure that you want to delete the circuit program from memory:
4. Move the '>' cursor to 'Y
es': Press
or