Siemens LOGO! Series - Summertime;Wintertime Conversion

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
Manual, 04/2011, A5E03556174-01
111
5. Press OK.
==
7RSUHYHQWXQLQWHQWLRQDOGHOHWLRQRI\RXU
FLUFXLWSURJUDP\RXDUHSURPSWHGWRHQWHU
\RXUSDVVZRUGSURYLGHG\RXKDYH
DVVLJQHGRQH
3DVVZRUG"
6. Enter your password.
7. Press O
K. The circuit program and the password are deleted.
3.7.14 Summertime/wintertime conversion
You can enable or disable automatic summertime/wintertime conversion
● in parameter assignment mode by calling the menu command "
①"

3UJ1DPH
6HW
6HW3DUDP
!6WRS
● in programming mode by calling the menu command "
②"

6WDUW
!6HWXS
&DUG
3URJUDP
To enable/disable automatic S/W Time conversion in programming mode:
1. Switch LOGO! to programming mode. LOGO! displays the main menu.
2. Select "
②": Press or
3. Confirm "
②": Press OK
4. Move the '>' cursor to "
③": Press or

%0$,180
0HQX/DQJ
/&'
!&ORFN
5. Confirm "
③": Press OK