Siemens LOGO! Series - Deleting a Block

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
Manual, 04/2011, A5E03556174-01
105
3.7.8 Deleting a block
Let us assume you want to delete the block B2 from your circuit program and connect B1
directly to Q1.
,
,
[
[
4
ุ
3DU
%
%
Proceed as follows:
1. Switch LOGO! to programming mode
(as a reminder, refer to the topic "The four golden rules for operating LOGO!" (Page 79)).

0VJ&RQILJ
3DVVZRUG
&OHDU3UJ
!(GLW
2. Select "
①": Press or
3. Confirm"
①": Press OK
(If required, enter your password and confirm with O
K.)
4. Select "
②": Press or

$4
0HPRU\"
(GLW1DPH
!(GLW3UJ
5. Confirm "
②": Press OK
6. Move the cursor to B2, the input of Q1: Press

%4


7. Confirm with O
K.
8. Now replace block B2 with block B1 at output Q1. The procedure:
– Select the B
N list: Press
or
– Accept the BN list: Press O
K
– Select 'B
1': Press
or
– Apply 'B1': Press O
K
R
esult: Block B2 is deleted, because it is no longer used in the circuit. Block B1 has replaced
B2 directly at the output.