Siemens LOGO! Series - Page 293

Configuring LOGO!
7.1 Selecting parameter assignment mode
LOGO!
Manual, 04/2011, A5E03556174-01
293
Current value of a counter
View of a counter parameter in parameter assignment mode:
&QW 
2II 
2Q 
%
&QW 
2IIൺ%
2Q 
%
RU
FXUUHQW
FRXQWYDOXH
You can change the on/off threshold. This does not apply if the on or off threshold represents
the result of another function (in the "
Up/down counter (Page 201)" topic, this is B021).
Current value of an hour counter
View of an hour counter parameter in parameter assignment mode:
P
0, K
%
7LPHLQWHUYDO
P
27 K
%
7RWDORSHUDWLQJKRXUV
P
01 K
%
7LPHWRJR
You can edit the configured time interval MI.
Current value of a threshold trigger
View of the parameter of a threshold trigger in parameter assignment mode:
ID 
2II 
2Q 
%
2QWKUHVKROG
2IIWKUHVKROG
3URFHVVYDULDEOH
You can change the on/off threshold.