Applicable cards
8.2 Inserting and removing the card from LOGO!
LOGO!
308 Manual, 04/2011, A5E03556174-01
To remove a battery card, or combined memory/battery card, slide a screwdriver with a 3-
mm blade into the slot on the upper surface of the card until it engages in the back, then with
the screwdriver engaged, pull the card out with your hand.
Removing the SD card slot cap from LOGO! 0BA7
To insert the SD card into the slot, you must first remove the slot cap with a screwdriver with
a 3-mm blade.
/2*2%$
Removing the SD card
To remove the SD card, pull the card out with your hand.
Inserting a memory card, battery card, combined memory/battery card or SD card
The entry of the card slot is chamfered on its bottom right. The edge of the cards is
chamfered accordingly. This encoding prevents you from inserting cards the wrong way.
Insert the card into the slot and push it in until it engages.
To Next Page
Loading...
