Siemens LOGO! Series - Page 84

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
84 Manual, 04/2011, A5E03556174-01
The LOGO!'s programming menu is as shown below:

0VJ&RQILJ
3DVVZRUG
&OHDU3UJ
!(GLW
Here you can also move the ">" cursor by pressing
and . Move the ">" cursor to "②" and
confirm with O
K.
The E
dit menu of LOGO! is as shown below:

$4
0HPRU\"
(GLW1DPH
!(GLW3UJ
Move the ">" cursor to "
③" (for editing the circuit program) and confirm with OK. LOGO! now
shows you the first output:

4


7KHILUVWRXWSXWRI/2*2
You are now in programming mode. Press
and to select the other outputs. Now start to
edit your circuit program.
N
ote
Because we have not yet saved a p
assword for the circuit program in LOGO!, you can
directly enter editing mode. When you select "Edit" after you have saved a password-
protected circuit program, you are prompted to enter a password and to confirm it with O
K.
You can only edit the program after you have entered the correct
password (Page 91).