Siemens LOGO! Series - Page 88

Programming LOGO!
3.7 Writing and starting the circuit program
LOGO!
88 Manual, 04/2011, A5E03556174-01

4
,ุ
%
Press OK. I1 is now connected to the input of the OR block. The cursor jumps to the next
input of the OR block.

4
,ุ
%
4
%
ุ
,
<RXUFRPSOHWHFLUFXLWSURJUDPLQ
/2*2XSWRQRZ
7KHGLVSOD\QRZVKRZV
Now you connect input I2 to the input of the OR block:
1. Switch to editing mode: Press OK
2. Select the Co list: Press
or
3. Confirm the Co list with: Press OK
4. Select I2: Press
or
5. Apply I2: Press OK
I2 is now connected to the input of the OR block:
B
,4
,ุ
%
4
%
ุ
,
,
<RXUFRPSOHWHFLUFXLWSURJUDP
LQ/2*2XSWRQRZ
7KHGLVSOD\QRZVKRZV
We do not need the last two inputs of the OR block for this circuit program. You can mark the
unused inputs with an 'x'. Enter the 'x' character twice:
1. Switch to editing mode: Press OK
2. Select the Co list: Press
or
3. Accept the Co list: Press OK
4. Select 'x': Press
or
5. Apply x: Press OK

%4


4
%
ุ
,
,
[
7KHGLVSOD\QRZVKRZV 7KLVLVWKHOD\RXWRI\RXU
FLUFXLWSURJUDP