Page 20 Milltronics SF 500 – INSTRUCTION MANUAL 7ML19985CN01
mmmmm
Modes of Operation
RUN Mode
To operate the SF 500 in RUN mode, program the unit with the base operating
parameters.
If you enter RUN mode before satisfying the program requirements, the PROGRAM
routine moves to the first missing item.
PROGRAM Mode
Use PROGRAM mode to change parameter values, and the way the unit operates.
• When the unit is initially powered, it starts in PROGRAM mode
• Ensure that the SW1 is set to the right (see Layout diagram on page 7)
• Program parameters define the calibration and operation of the SF 500
•By entering PROGRAM mode, the user can view the parameter values or EDIT them
to suit the application
•When in PROGRAM Mode the unit identifies the name of the parameter, the
description, and the options or instructions for making a valid entry
PROGRAM Mode Display
VIEW
EDIT
Scrolls through RUN Displays
Resets Totalizer 1
Clear Entry
Toggle bet w een VIEW and EDIT
or use to enter parameter values
P001 Language V
1-Eng 1
P001 Language E
1-Eng 1
Key PROGRAM Mode RUN Mode
SPAN
ALT
DISP
RESET
TOTAL
CLEAR
ENTER
To Next Page
Loading...
