Siemens Milltronics SF 500 - Entering PROGRAM Mode

7ML19985CN01 Milltronics SF 500 – INSTRUCTION MANUAL Page 21
mmmmm
Modes of Opearation
Entering PROGRAM mode
Press
Selecting a parameter:
Scroll:
Press to move up,
Press to move down.
Accessing a parameter directly:
Press
Press in sequence.
Or press
P001 Language V
1-Eng 1
P002 Test Reference Selection V
1-Weight, 2-ECal 1
P001 Language V
1-Eng 1
View/Edit Parameter
Enter Parameter Number
P011 Design Rate: V
Enter Rate 100.00 kg/h
P940-2 Load Cell mV Signal Test V
mV reading for B 6.78
The default of previous parameter view is
displayed.
e.g. P001 is the default parameter for initial
start up.
e.g. scrolls up from P001 to P002.
e.g. scrolls down from P002 to P001
For direct access to index parameters
e.g. access P011, design rate
e.g. access P940-2, load cell B mV signal