7ML19985CN01 Milltronics SF 500 – INSTRUCTION MANUAL Page 1
mmmmm
Introduction
Milltronics SF 500
The Milltronics SF 500 is a full-feature integrator for use with solids flowmeters. The SF
500 processes the signal from the flowmeter and calculates values for the rate of
material flow and totalization. These values are displayed on the local LCD, or output in
the form of analog mA, alarm relay, or remote totalization.
Milltronics SF 500 features
The SF 500 is programmable
• Two remote totalizer contacts
• Five programmable relays
• Five programmable discrete inputs
• One programmable isolated mA output for rate (standard)
• Two programmable isolated mA input, for PID control
• Two programmable isolated mA output for rate, PID control, or on-line
calibration
The SF 500 is flexible
• Rate linearization
•Auto zero
• PID* control
• Batch control
• Multispan operation
• On-line calibration
* PID and on-line calibration control requires the optional mA I/O board.
The SF 500 can communicate
There are three communication ports on the SF 500, as standard. Use the two RS-232
ports for Milltronics Dolphin Plus and Modbus protocol. Link the RS-485 port to either a
PLC or a computer. The SF 500 also supports Siemens Milltronics SmartLinx® and
networks with popular industrial communication systems.
The SF 500 is upgradeable
Enhance its basic features with the following:
•mA I/O board
• SmartLinx module
Note: The Milltronics SF 500 is to be used only in the manner outlined in this
instruction manual.
To Next Page
Loading...
