Siemens Milltronics SF 500 - Page 28

Page 22 Milltronics SF 500 – INSTRUCTION MANUAL 7ML19985CN01
mmmmm
Modes of Operation
Changing a parameter value:
Press
Press
Resetting a parameter value:
Press
Press
P011 Design Rate: V
Enter Rate 100.00 kg/h
P011 Design Rate: E
Enter Rate 100.00 kg/h
P017 Test Rate Weight V
80.00 kg/h
P011 Design Rate: E
Enter Rate 200.00 kg/h
P011 Design Rate: V
Enter Rate 0.00 kg/h
from the view mode
If EDIT mode is not enabled after pressing
ENTER, Security is locked. Refer to
Parameters\ Security Lock (P000) on
page 92 for instructions on disabling
Enter the new value
For P001 to P017, ENTER completes the
change and scrolls to the next required
parameter.
Enter the CLEAR function
Value is reset to factory value.
e.g. 0.00 kg/h
from the EDIT mode