The default reading cycle is 86400 seconds, which is one day.
You can find additional information on supported protocols in the chapter
Configuring protocols.
4. Enter data source data and confirm with "Accept".
5. To save the data source click "Save".
Result
You have now created a new data source. The new data source is available at the asset details of
your MindConnect IoT2040.
The following graphic shows the added data source:
3.4 Adding data points for MindConnect IoT2040
A data point is a measurable value of an asset that can be represented numerically and
graphically. Examples of a data point are temperature or pressure. You can add data points to a
data source to collect the data for example from a control unit. In the next step you have to link
the data points of a data source with the respective variables of an aspect.
You can find more information about how to send data in chapter Send commands for IoT2040.
Limitations
One data point cannot be mapped to two variables in the same aspect.
To Next Page
Loading...
