Siemens MindConnect IoT2040 - Importing Data Source Configurations for Mindconnect Nano

3.7 Configuring MindConnect IoT2040 using API
AgentManagement API
You can configure MindConnect IoT2040 via api calls with public API’s that are offered from
Industrial IoT. To update the data source configuration of AgentManagement api, refer to the
endpoint "Data Source Configuration Operations" in Agent Management Service – API
Specification.
For more information on how to authenticate and how to get the information related with the
MindConnect element from Industrial IoT, refer to Develop for Industrial IoT.
This below information will show, how to structure the configuration part for the above api
request for specific industrial protocols.
Protocol configurations
You can configure the device to AgentManagement using the below protocol specific
configurations that needs to be configured in the api call.
In case the body structure is not as expected, the configuration might be rejected or
may lead to corrupt configuration. Always verify the operation from MindConnect
Element UI.
The json configuration in body part of the request consists of below key-value pairs. All the
documented key-value pairs given below are important. The child fields of
and items are free formatted fields and should be a valid json. Below is the
configuration body:
customData dataPo
ints dataSource
{
"name": "DataSource Name",
"customData": {
Configuring data in Asset Manager
3.7 Configuring MindConnect IoT2040 using API
MindConnect IoT2040
System Manual 8/202335