You can choose the SYSTEM protocol as a data source without configuring specific system
parameters, except the reading cycle.
After creating the data source you can configure the following categories in a new data point:
CPU
Memory
Network
Disk
The following image shows the data point input window for the SYSTEM protocol:
Each category has its own set of variables which will be described in the following.
Application information
Application provides the following available applications:
MindEdgeRuntimeSystem/java
DataProvider
BoxManager
S7 Plugin
OPC UA Plugin
XTools
Mosquitto
The following table shows the available variables for the applications:
To Next Page
Loading...
Need help?
General