UM353-1 Contents
March 2003 vii
LIST OF TABLES
TABLE AND TITLE PAGE
1.1 Contact Information........................................................................................................................................ 1-7
1.2 ISO/IEC Symbols ........................................................................................................................................... 1-8
3.1 Security Level vs. Accessible Operations....................................................................................................... 3-4
3.2 Modbus Port Baud Rate Parameters ............................................................................................................... 3-6
3.3 Board Description and ID with Example Hardware and Software Revisions ................................................ 3-6
3.4 Input Types ................................................................................................................................................... 3-19
3.5 Calibration Input Values............................................................................................................................... 3-19
3.6 Sen Min/Max & Min/Max Scale Parameters................................................................................................ 3-19
8.1 Rear Terminal Assignments............................................................................................................................ 6-8
8.2 Factory Calibration ....................................................................................................................................... 6-26
9.1 Autotune Errors .............................................................................................................................................. 9-6
9.2 Autotune Warnings......................................................................................................................................... 9-6
11.1 RTC/CB and RCB Boards, Off-Line Error Codes........................................................................................ 11-9
11.2 On-Line Error and Status Codes................................................................................................................. 11-10
14.1 Moore 353 Model Designation..................................................................................................................... 12-2
Changes for Revision 11, March 2003
Significant changes for Rev 11 are indicated by change bars in the outside page margins. Some of these changes are
listed below.
SECTION CHANGE
Cover Changed to Rev. 11, March 2003.
1 Introduction Table 1.1 Contact Information updated.
2 Configuration Overview Ethernet function block list in Section 2.5 updated.
3 Function Blocks AIE, CIE, DIE, ODA, ODC, ODD, ODP, ODS, and RLM blocks updated.
AWE, CWE, and DWE blocks added.
11 Maintenance Jumper illustration in Section 11.5.5 updated.
Warranty Updated.
SR353-10 Replaces SR353-8.
Note
At Rev. 9, the User’s Manual was reorganized to move the FCO and Network
Communications appendices into the body of the manual, as in the Procidia i|pac User’s
Manual. The Function Block section is now followed by the FCO section and the
Network Communications section is now followed by the Data Mapping section
(previously Appendix A Network Communications).
To Next Page
Loading...
Need help?
General
