Contents vii
Contents
4 Troubleshooting the System 4-1
Calibration Failures 4-1
Calibration or Slope Drift 4-1
Calibration or Slope No Endpoint 4-2
Calibration or Slope Outside Range 4-4
Fluidics Failure, Insufficient 7.3/6.8/Wash 4-5
Suspect Results 4-6
Sample Not Detected or Sampling Fault 4-7
Printer Problems 4-8
Hydraulic Problems 4-9
Heater Problems 4-10
Using the Troubleshooting Routines 4-10
Measurement Block Routine 4-10
Sample Flow Routine 4-12
Heater Routine 4-13
Electronics Routine 4-13
Roll Printer Routine 4-13
Using the Status Indicators 4-14
Other Problems 4-14
5 Configuring the System 5-1
Operating Setup 5-1
Setting QC Ranges 5-1
Setting Reference Ranges 5-2
Choosing Units 5-2
Selecting Calibration Method, and Entering Gas Values 5-2
Setting Printer Options 5-3
To Next Page
Loading...
