Approvals, certificates, standards
9.2 Product group X-300M
SCALANCE X-300
Operating Instructions, 05/2016, A5E01113043-20
231
The product is a component in compliance with the EC Machinery Directive 2006/42//EEC.
According to the machinery directive, we are obliged to point out that the product described
is intended solely for installation in a machine.
Before the final product can be put into operation, it must be tested to ensure that it conforms
with the directive 2006/42/EEC.
Note
Note for the manufacturers of machines
This product is not a machine in the sense of the EC
Machinery Directive. There is therefore
no declaration of conformity relating to the EC Machinery Directive 2006/42/EEC for this
product.
Note for the manufacturers of machines
This product is not a machine in the sense of the EC Machinery Directive. There is therefore
no declaration of conformity relating to the EC Machinery Directive 89/392/EEC for this
product.
ATEX (explosion protection directive)
When using SIMATIC NET products in hazardous area zone 2, make absolutely sure that
the associated conditions in the following document are adhered to:
"SIMATIC NET Product Information Use of subasseblies/modules in a Zone 2 Hazardous
Area".
You will find this document
• on the data medium that ships with some devices.
• on the Internet pages of Siemens Industry Online Support
(http://support.automation.siemens.com/WW/view/en
).
Enter the document identification number C234 as the search term.
SIMATIC NET products meet the requirements of the EC directive:94/9/EC "Equipment and
Protective Devices for Use in Potentially Explosive Atmospheres".
ATEX classification:
II 3 G Ex nA IIC T4 Gc
KEMA 07ATEX0145 X
The products meet the requirements of the following standards:
● EN 60079-15: 2010 (electrical apparatus for potentially explosive atmospheres; Type of
protection "n")
● EN 60079-0: 2009 (Explosive atmospheres - Part 0: Equipment - General requirements)
To Next Page
Loading...
Need help?
General