Siemens SIMATIC ET 200SP HA - Parameters;address space

Parameters
5
5.1 Con󹪝guration options
De󹪝nition
The selected con󹪝guration determines the scope of the input and output address areas that are
used in the I/O system.
Description
The following con󹪝gurations, each with value status, are possible:
• without HART variables in the input address area
• with 4 HART variables in the input address area
• with one multiHART range in the input/output address area
Con󹪝guration options
When con󹪝guring is done in HW Con󹪝g, the con󹪝guration is carried out indirectly in the
parameter assignment dialog of the module.
Note
Only the listed con󹪝gurations can be directly con󹪝gured for the I/O module while the CPU is in
RUN mode. To set another con󹪝guration, 󹪝rst remove the I/O module in CPU RUN. You then add
the I/O module with the new con󹪝guration while the CPU is in RUN mode. Also note a resulting
change in the I/O address area.
5.2 Parameter types
De󹪝nition
You de󹪝ne operation of the I/O module and thereby in󹪞uence the functions supported by the
module via the parameter types.
AI 4xI 2-/4-wire HART ISOL HA
Equipment Manual, 07/2022, A5E50101523-AB 21