Siemens SIMATIC ET 200SP HA - HART Mapping Parameters

5.5 HART mapping parameters
De󹪝nition
The HART mapping parameters allow a maximum of 4 HART variables to be con󹪝gured (mapped)
in the input address space of the I/O module.
If you want to use the maximum of 4 HART variables directly in the input range of the I/O module,
assign these parameters in the properties dialog of the I/O module.
Description
You have the following setting options:
Parameter Value range Default Parameter reassign‐
ment in RUN
Variable 0 Channel 0…3 0 Yes
Type
• Primary
• Secondary
• Tertiary
• Quaternary
• CiR
CiR Yes
:
:
Variable 3 Channel 0…3 0 Yes
Type
• Primary
• Secondary
• Tertiary
• Quaternary
• CiR
CiR Yes
Parameters
5.5 HART mapping parameters
AI 4xI 2-/4-wire HART ISOL HA
30 Equipment Manual, 07/2022, A5E50101523-AB