Siemens SIMATIC Field PG M6 - Replacing the SSD

Maintaining and repairing the device
8.1 Installing and removing hardware
SIMATIC Field PG M6
66 Operating Instructions, 12/2018, A5E43198909-AA
8.1.3
Replacing the SSD
Requirements
Note
Only replace the SSD with an SSD of the same type.
SSDs are available as SSD units in a kit.
Information about this can be found in section
"
SSD kit (Page 64)".
● The device is not in Standby or Hibernate mode (unsaved data might be lost) or the
device can get damaged.
● The device is completely isolated from the line voltage.
● The battery has been removed, see section "Using batteries (Page 46)".
● All connecting cables have been removed from the device.
Removing the SSD unit
1.
Open the display.
2.
Remove both screws (Torx
T8) on
the cover of the SSD unit.
3.
Open the cov
er and pull out the
SSD unit.