Siemens SIMATIC FM 353 - Page 183

Human-machine Interface
8-7
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
Table 8-1 below describes the individual screens of the user interface.
Table 8-1 Description of the screens in the user interface
Screen name
Screen
No.
Description
Main screen PIC7 This screen is displayed to you after the OP 07 is enabled. The
FM353 values are display values. You can use the soft keys to call up
the following main screens:
S Softkey “Istw” → PIC71
S Softkey “IBN” → PIC72
S Softkey “Diag” →PIC73
S Softkey “Anw” → PIC74
Main screen, actual
value display
PIC71 The values on the screen are display values. You can use the soft
keys to call up the following screens:
S Softkey “Teach” → PIC711
S Softkey “BA-E” → PIC712
S Softkey “Auto” → PIC713
S Softkey “Eist” → PIC714
Main screen, startup PIC72 The FM 353 values (service data) are display values. You can use the
soft keys to call up the following screens:
S Softkey “MD” →PIC722
S Softkey “Eins” → PIC723
S Softkey “Anw” → PIC724
Main screen, diag-
nostics
PIC73 This screen shows you the diagnostic interrupts and error messages
for the FM 353 in four lower-level screens. The following are dis-
played:
S Error class and error number for operator control and guidance
errors
S The bit numbers of the single diagnostic interrupt bytes
You can use the soft keys “Quit” and “Res” to acknowledge the errors.
See Chapter 11.3 for diagnostic interrupts and error messages
User screens PIC74
and
PIC724
You can use these screens to configure your own contents.
Setting data for oper-
ating mode
PIC712 This screen contains input/output fields for the velocity levels or a text
field for selecting velocity level (selections 1 or 2 possible). You can
use the soft keys to call up the following screens:
S Softkey “Steu” → PIC7122
S Softkey “SMR” → PIC7123
S Softkey “MDI”→ PIC7124
Setting data for the
“Automatic” operating
mode
PIC713 This screen contains only display fields. You can use the “Anwahl”
soft key to call up screen PIC 7132.
Set Actual value PIC714 The actual value display is a display field. The value for set an actual
value appears in an input/output field. You can use the soft key
“NPVer” to call up the screen PIC7141. You can use the soft keys
“Iwrü” and “IWset” to execute functions.