Troubleshooting
11-31
FM 353 Stepper Drive Positioning Module
6ES7 353-1AH01-8BG0
Table 11-8 General data errors, machine data errors, traversing program errors, continued
Cl.
Mes-
sage/
Display
Error message,
error analysis and remedy
No.
Traversing program errors Error response: “Warning” see Table 11-2
8 (08) 25 (19) G function 2 unacceptable CBS
Cause The number programmed as G function 2 is not allowed.
or
Effect Program/block not stored
DB
Elimination Correct program, per cause
8 (08) 26 (1A) G function 3 unacceptable CBS
Cause S The number programmed as G function 3 is not allowed.
S External block change (G50) was programmed in a block
together with continuous operation for setting actual
value on the fly (G88/89).
S A tool offset (G43, G44) was called up without D number.
S In selecting a D number, the direction specification is
missing for the tool offset (G43, G44).
or
DB
Effect Program/block not stored
Elimination Correct program, per cause
8 (08) 27 (1B) M-function unacceptable CBS
Cause S The number programmed as M-function is not allowed.
S At least two of the M functions M0, M2, M18, M30, which
cancel each other out, are found in one block.
or
DB
Effect Program/block not stored
Elimination Correct program, per cause
8 (08) 28 (1C) Position/dwell time missing CBS
Cause S No dwell time specified in block with G04.
S Target position missing with external block change
(G50).
S No new actual value programmed for the function contin-
uous operation with setting actual value on the fly
(G88/89).
or
DB
Effect Program/block not stored
Elimination Correct program, per cause
8 (08) 29 (1D) Incorrect D-NO (>20) CBS
Cause The number for tool offset is greater than 20
or
Effect Program/block not stored
DB
Elimin. Correct program, per cause
Cl. = Detail event class, No. = Detail event number, CBS = checkback signals, DB = data block
Note: Value (xx) = Hexadecimal notation of the error number
To Next Page
Loading...
