Installing and connecting the device
3.4 Installing the tool and driver
IFP Basic
Operating Instructions, 06/2023, A5E46178354 - AD
41
3.3.6 Connecting a USB device
You can connect the following industry-standard devices to the USB ports of the device:
• External mouse
• External keyboard
• USB flash drive
Note when connecting
Wait at least ten seconds between removal and reconnection of USB devices.
When using standard USB peripherals, bear in mind that their EMC immunity level is
frequently designed for office applications only. These devices may be used for
commissioning and servicing. However, only industry-standard devices are allowed for
industrial operation.
Peripherals are developed and marketed by individual vendors. The respective supplier
offers support for the I/O devices. Moreover, the terms of liability of the individual vendors
or suppliers apply here.
nal problem with USB port
If you connect an external device with a 230 VAC power supply to the USB port without using
a non
-insulated installation, you may experience functional problems.
n port
A USB device with too high a power load may possibly cause functional problems.
Observe the values for the maximum load of the USB interface. You will find the values in the
section "Technical specifications" (Page 67)".
3.4 Installing the tool and driver
You need to install the following software on the PC:
• Brightness Adjustment Tool
• eGalax Touch Driver
You can download the software package of eGalax Touch Driver and the Brightness
Adjustment Tool on SIOS (https://support.industry.siemens.com/cs/ww/en/view/109812464).
The following section describes the detailed information of installing the eGalax Touch Driver
and the Brightness Adjustment Tool.
Requirements for installing the Brightness Adjustment Tool
• Windows 7/Windows Embedded Standard 7/Windows 10 Operating System is installed in
your IPC.
• Your IFP device is connected with a PC.
To Next Page
Loading...