Operating the device
5.3 Using the Brightness Adjustment Tool
IFP Basic
Operating Instructions, 06/2023, A5E46178354 - AD
47
5.3 Using the Brightness Adjustment Tool
Ensure you have installed the Brightness Adjustment Tool.
Adjust the brightness
1. Click the monitor to select the monitor you want to adjust the brightness.
– To select multiple monitors, click the connected monitors one by one. You can select
all connected monitors by ticking "Select all connected monitors".
– To unselect the monitor, click the selected monitor again.
2. Adjust the brightness in either of the following ways:
– click "+" or "-"
– Drag and drop the brightness slider.
Set the brightness at system startup to 100%
Tick "set the brightness value at system start up".
Adjust the VGA display
AUTO ADJUST
When the VGA display is abnormal (for example, incomplete display), you can adjust the
display as the following steps:
1. Click the monitor to select the monitor you want to adjust the display.
2. Click "AUTO ADJUST".
For more information on the VGA display, refer to Troubleshooting (Page 78).
To Next Page
Loading...