Siemens SIMATIC IPC277G - Page 71

Technical specifications
8.1 Certificates and approvals
SIMATIC IPC277G
Operating Instructions, 08/2021, A5E50059956-AA
71
2014/35/EU Directive of the European Parliament and of the Council of 26 February 2014 on
the harmonisation of the laws of the Member States relating to the making available on the
market of electrical equipment designed for use within certain voltage limits; Official Journal
of the EU L96, 29/03/2014, p. 357–374 (from 20.04.2016)
EMC
EN 61000-6-1, EN 61000-6-2, EN 61000-6-3;
LVD
EN 61010-2-201:2013;
FCC and Canada
USA
Federal Communications
Commission
Radio Frequency
Interference Statement
This equipment has been tested and found to comply with the limits for a
Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are
designed to provide reasonable protection against harmful interference
when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if
not installed and used in accordance with the instruction manual, may
cause harmful interference to radio communications. Operation of this
equipment in a residential area is likely to cause harmful interference in
which case the user will be required to correct the interference at his own
expense.
Shielded cables
Shielded cables must be used with this equipment to maintain compliance
with FCC regulations.
Modifications
Changes or modifications not expressly approved by the manufacturer
could void the user's authority to operate the equipment.
Conditions of operations
This device complies with Part 15 of the FCC Rules. Operation is subject to
the following two conditions: (1) this device may not cause harmful
interference, and (2) this device must accept any interference received,
including interference that may cause undesired operation.
CANADA
Canadian notice
This Class B digital apparatus complies with Canadian ICES-003.
Avis Canadian
Cet appareil numérique de la classe B est conforme à la norme NMB-003
du Canada.
Responsible party for Supplier's Declaration of Conformity
Siemens Industry, Inc.
Digital Factory - Factory Automation
5300 Triangle Parkway, Suite 100
Norcross, GA 30092
USA
Mail to: (amps.automation@siemens.com)