Configuring with Web Based Management
5.6 "Interfaces" menu
SCALANCE W760/W720 to IEEE 802.11n Web Based Management
172 Configuration Manual, 11/2014, C79000-G8976-C350-03
●
Specify the frequency band. In client mode, dual-frequency operation is also possible.
Note
Configuring WLAN interfaces of the W786-2IA RJ-45 for different frequency bands
If both WLAN interfaces are configured for the same frequency band on this device, there
may be mutual influence or interference. This applies in particular when there is a high
data throughput.
●
Select the required transmission standard for the configured frequency band.
– WLAN Mode 2.4 GHz
Specify the transmission standard for the 2.4 GHz frequency band. The selection
depends on the country setting.
– WLAN Mode 5 GHz
Specify the transmission standard for the 5 GHz frequency band. The selection
depends on the country setting.
●
Enables or disables the "Dynamic Frequency Selection (DFS)" function.
– Enabled
If the access point discovers a disruption on the current channel, for example due to a
primary user, it automatically switches to an alternative channel. DFS is also the
requirement for the use of certain wireless channels.
– Disabled
The DFS function is not used.
To Next Page
Loading...
Need help?
General
