Configuring the Computing Unit in BIOS Setup
Release 04/02
5-10
Panel PC 670 Computing Unit, Equipment Manual
Submenu ”Boot Options”
The following submenu appears when you select the option “Boot Options” in
the main menu:
PhoenixBIOS Setup Utility
Item Specific Help
QuickBoot Mode:
ESC Exit
Select Item
Select Menu
+ / –
Select
Change Values
Sub-Menu
F9
F10
Setup Defaults
Save and Exit
SETUP prompt: [Enabled]
POST Errors: [Enabled]
Floppy check:
Allows the system to
skip certain tests
while booting. This
will decrease the
time needed to boot
the system.
Enter
Help
F1
Main
Boot Options
[Enabled]
Summary screen:
[Disabled]
[Enabled]
Figure 5-5 ”Boot Options” Submenu
Quick Boot
Mode
Some hardware tests are skipped when the system starts up, thus
speeding up the boot procedure.
SETUP prompt The message PRESS <F2> to enter Setup appears at the bottom of
the screen during the system load phase.
POST Errors The boot process is stopped if an error is detected; you must press F1 to
acknowledge. Enter “Disabled”to avoid the necessity of acknowledging
errors, for example if no keyboard is connected.
To Next Page
Loading...
