Configuring the Computing Unit in BIOS Setup
Release 04/02
5-25
Panel PC 670 Computing Unit, Equipment Manual
Hard Disk
Timeout
[Disabled] The hard disk does not shut down.
[10, 15, 30, 60] Time since the last hard-disk access, the hard disk
is shut down. On the next
access the hard disk will be activated again
with a short delay.
5.1.5 Menu Boot-Sequence
Overview
This menu lists the boot devices in prioritized groups.
PhoenixBIOS Setup Utility
Item Specific Help
ESC Exit
Select Item
Select Menu
+ / –
Select
Change Values
Sub-Menu
F9
F10
Setup Defaults
Save and Exit
Enter
Help
F1
Advanced Security Version ExitMain Power
Keys used to view or
configure devices:
<Enter> expands or
collapses devices with
a + or –
<Ctrl+Enter> expands
all
<+> and <–> moves
the device up or down.
Boot Sequence
+ Removable Device
+ Hard Drive
ATAPI CD-ROM Drive
Figure 5-18 “Boot Sequence” Menu
This menu lists the boot devices in groups. The group with the highest priority is at
the top. The procedure for changing the sequence is as follows:
Use the ↑↓ keys to select a group and the + or – keys to move the group to its
new position in the sequence.
Note
During booting the boot drive can be selected with the ESC key.
To Next Page
Loading...
