Printing the Sequencer
S7-GRAPH for S7 300/400 Programming Sequential Control Systems
12-2 C79000-G7076-C526-01
"Print" Tab Page, "Application Settings" Dialog Box
in the "Print" tab page of the "Application Settings", you can specify the standard
settings for printouts. You select the required settings by placing a check mark.
You can, for example, include the following components in the printout:
• Cross references for actions and addresses
• The entire address list
• Permanent instructions with address list
• Variables
Creating the Headers and Footers in the SIMATIC Manager
To specify the header and footer lines for your documents, use the menu command
File > Headers and Footers in the SIMATIC manager.
Selecting the Page Format
With the menu command File > Page Setup, you can select the page format you
require for your printout.
Checking the Current Block in the Print Preview
With the menu command File > Print Preview, you can check all the settings for
the current block before you send the document to the printer. Editing is not
possible in this view.
Starting the Print Job
You can start the print function in two ways in S7-Graph:
•
Select the “Print" button in the toolbar.
•
Select the menu command File > Print.
A dialog box is then opened in which you can select various print options such as
the printer and number of copies.
Confirm with OK to send the document to the printer.
To Next Page
Loading...
Need help?
General
