General information and safety notes
1.3 Intended use
BA 2030 (2KJ4)
Operating Instructions, 07/2020, A5E50009094A/RS-AL
9
1.3 Intended use
The SIMOGEAR gearboxes described in these operating instructions have been designed for
stationary use in general engineering applications.
Unless otherwise agreed, the gearboxes have been designed for use in plants and equipment
in industrial environments.
The gearboxes have been built based on state-of-the-art technology and are shipped in an
operationally reliable condition. Changes made by users could affect this operational
reliability and are forbidden.
Note
The data on the rating plate assumes an installation altitude of up to 1000
m above sea level.
The permissible ambient temperature is stamped on th
e rating plate.
For different installation altitudes and ambient temperatures, contact Technical Support.
The gearboxes have been designed solely for the application described in the Technical data
(Page 81). Do not operate the gearbox outside the specified power limit. Other operating
conditions must be contractually agreed.
Do not climb on the gearbox. Do not place any objects on the gearbox.
1.4 Obligations of the user
The operator must ensure that all persons assigned to work on the geared motor have read
and understood these operating instructions and that they follow them in all points in order
to:
• Eliminate the risk to life and limb of users and other persons.
• Ensure the operational safety of the geared motor.
• Avoid disruptions and environmental damage through incorrect use.
Note the following safety information:
Shut down the geared motors and disconnect the power before you carry out any work on
them.
Make sure that the drive component cannot be turned on accidentally, for example, lock the
key-operated switch. Place a warning notice at the drive connection point which clearly
indicates that work is in progress on the geared motor.
Carry out all work with great care and with due regard to "safety".
For all work, observe the relevant regulations for work safety and environment protection.
Read the instructions on the rating plates attached to the geared motor. The rating plates
must always be kept free from paint and dirt. Replace if missing.
In the event of changes during operation, switch off the drive component immediately.
To Next Page
Loading...
