Siemens SIMOGEAR BA 2030 - Checking and Changing Lubricants; General Safety Notes

Service and maintenance
8.2 Checking and changing lubricants
BA 2030 (2KJ4)
60 Operating Instructions, 07/2020, A5E50009094A/RS-AL
Remedy
Interval
Description of work
Carry out a complete inspection
of the geared motor.
Every 12 months.
Inspecting the gearbox
(Page 78)
Check the friction clutch and
adjust if necessary.
After 500 hours, thereafter once
a year and after every blockage.
Observe the BA 2039 (2KJ4)
Operating Instructions.
Check the coupling.
For the first time after 3 months.
Please refer to the separate
operating instructions.
Check that fastening bolts on
gearboxes and add-on elements
are securely tightened. Check
that covers and plugs are secure-
ly fastened.
After 3 hours, and then every 2
years.
Checking the tightness of fas-
tening bolts (Page 77)
Change the roller bearing
grease.
When the oil is changed.
Change the roller bearing grease
(Page 68)
Replace the bearing.
-
Replace bearings (Page 75)
Check the rubber buffer of the
torque arms.
Every 6 months.
Torque arms with shaft-
mounted gearboxes (Page 44)
Check the hose of the oil expan-
sion unit.
Check regularly; renew every 4
years at the latest.
Replacing the hose of the oil
expansion unit (Page 78)
Lubricate the XLplus and VLplus
heavy-duty bearing systems.
-
Lubrication of the XLplus and
VLplus heavy-duty bearing sys-
tems (Page 72)
1)
When using synthetic oils, the intervals can be doubled. The data specified is valid for an oil tem-
perature of +80 °C. See the figure titled "Guide values for oil change intervals" for the intervals for
other temperatures.
8.2 Checking and changing lubricants
8.2.1 General safety notes
WARNING
Danger of scalding from the hot oil emerging from the unit
Before starting any work wait until the oil has cooled down to below +30 °C.
WARNING
Risk of slipping on oil
Remove any oil spillage immediately with an oil-binding agent in compliance with
environmental requirements.