BA 2030 (2KJ4)
Operating Instructions, 07/2020, A5E50009094A/RS-AL
25
4.1 Unpacking
Transport damage impairs the correct function of the gearbox
Never commission faulty gearboxes.
Check the gearbox for completeness and for damage. Report any missing parts or damage
immediately.
Remove and dispose of the packaging material and transport equipment in compliance with
regulations.
4.2 General information on installation
Operating under load
Under load, the system can start or reverse in an uncontrolled fashion.
The entire system must be load-free so that there is no danger during this work.
Destruction caused by welding
Welding destroys the geared parts and bearings.
Do not weld on the gearbox. The gearbox must not be used as a grounding point for
Overheating caused by solar radiation
Overheating of the gearbox due to exposure to direct sunlight.
Provide suitable protective equipment such as covers or roofs. Prevent heat accumulation.
To Next Page
Loading...
