Siemens SIMOGEAR BA 2030 - Recommended Lubricants

Service and maintenance
8.2 Checking and changing lubricants
BA 2030 (2KJ4)
70 Operating Instructions, 07/2020, A5E50009094A/RS-AL
8.2.9 Recommended lubricants
The released and recommended lubricants are listed in the table NT 7300
(https://support.industry.siemens.com/cs/ww/en/view/109753864).
DANGER
Used lubricants only have conditional approval
The used lubricants are not or only conditionally approved for use in the foodstuff or
pharmaceutical industry.
Use only lubricants with USDA (United States Department of Agriculture) H1 / H2 approval
for deployment in the foodstuff or pharmaceutical industry.
NOTICE
Incorrect operating temperatures impair lubricity of the gearbox oil
Operating temperatures outside the permitted range impair the lubricating property of the
gearbox oil.
For this, observe the permissible oil sump temperatures listed in the lubricant table.
The oil used must be approved for use in the ambient temperature range given on the
rating plate.
When changing the oil, please observe the operating temperature range of the new oil as
specified by the oil manufacturer.
Note
As standard, the lubricants and shaft seals are harmonized and
coordinated with one another
corresponding to the prevailing operating conditions.
Contact Technical Support for:
•
Change of the operating conditions
•
Change in oil grade
•
Deployment of new shaft seals.
Note
The lubricants used are not at all or only con
ditionally biodegradable. If biologically
degradable lubricants are required, use only gearbox lubricants with the appropriate
classification listed in the NT 7300 table.
Note
We recommend the use of CLP
ISO PG oils for gearboxes of frame sizes 169 and 189 with a
service factor f
B
<1.2.
Note
These recommendations are not a guarantee of the lubricant quality provided by your
supplier. All lubricant manufacturers are responsible for the quality of their own products.