Service and maintenance
8.7 Checking the oil level sensor (optional)
BA 2030 (2KJ4)
76 Operating Instructions, 07/2020, A5E50009094A/RS-AL
8.7 Checking the oil level sensor (optional)
The oil level sensor indicates the oil level only when the gearbox is shut down.
Lower the oil level and fill it up again until the oil level sensor gives a switching signal.
Please refer to the separate operating instructions for the oil level sensor.
8.8 Cleaning the gearbox
Dust deposits cause higher housing temperatures
Dust deposits prevent heat radiation.
Keep the geared motor free from dirt and dust.
Cleaning with a high-pressure cleaning appliance
Water can penetrate into the geared motor. Seals can become damaged.
Do not use a high-pressure cleaning appliance to clean the geared motor.
Do not use tools with sharp edges.
Switch off the power supply to the drive component before cleaning it.
To Next Page
Loading...
