Installation
4.9 Installing and removing the shaft-mounted gearbox
BA 2030 (2KJ4)
Operating Instructions, 07/2020, A5E50009094A/RS-AL
43
4.9.4 Hollow shaft with splines
Not included in the scope of supply
Figure 4-9 Mounting the hollow shaft with splines
Instead of the nut and threaded spindle shown in the diagram, other types of equipment
such as hydraulic lifting equipment may be used.
Procedure
1. Using benzine or a solvent, remove the anti-corrosion protection from the shaft extensions
and flanges.
2. Check the seats or edges of the hollow and machine shafts for damage. Please contact
Technical Support if you notice any damage.
3. Apply the mounting paste ⑦ to the machine shaft ①. Apply the paste uniformly.
4. Fit the gearbox using the disk ⑤, threaded spindle ④ and nut ③. Support is provided by the
hollow shaft â‘¡.
5. Replace the nut â‘¢ and the threaded spindle â‘£ with a screw. Tighten the bolts to the
specified torque.
You have mounted the hollow shaft with splined shaft.
Table 4- 9 Tightening torque for the screw
To Next Page
Loading...
