Installation
4.7 Mounting an input or output element on the gearbox shaft
BA 2030 (2KJ4)
Operating Instructions, 07/2020, A5E50009094A/RS-AL
31
Damage caused by improper handling
Bearings, housing, shaft and locking rings are damaged due to improper handling.
Do not use impacts or knocks to force the input and output elements to be mounted onto
Deburr the parts of elements to be fitted in the area of the hole or keyways.
Recommendation: 0.2 x 45°
Where couplings are to be fitted in a heated condition, observe the specific operating
instructions for the coupling. Unless otherwise specified, apply the heat inductively using a
torch or in a furnace.
Use the center holes in the shaft extension faces.
Use a fitting device to fit the input or output elements.
Figure 4-1 Example of a fitting device
To Next Page
Loading...
