Installation
4.8 Removing and installing the protection cover
BA 2030 (2KJ4)
Operating Instructions, 07/2020, A5E50009094A/RS-AL
33
Figure 4-3 Protection cover for hollow shaft
Procedure
Premounted protection cover
1. Release the screws â‘ and remove the protection cover â‘¡ together with the flat gasket or O-
ring â‘¢.
2. Mount the output shaft.
3. Use a suitable cleaning agent to clean the contact surface of the protection cover â‘¡ on the
gearbox.
4. Ensure that the flat seal or the O-ring â‘¢ is correctly seated.
5. Wet the bolts â‘ with medium-strength adhesive, e.g. Loctite 243.
6. Screw on the protection cover â‘¡.
7. Protect all remaining bare areas with a suitable permanent anti-corrosive agent.
You have now installed the protection cover for operation.
To Next Page
Loading...
