Siemens SIMOTICS CONNECT 400 - 5 Commissioning the Router Kit WLAN; LTE; Preparing the Hardware; Setting up Interfaces

5 Commissioning the Router Kit WLAN / LTE
5.1 Preparing the hardware
Application example for SIMOTICS CONNECT 400 - Router KitInbetriebnahme- und Montagehandbuch 43
5 Commissioning the Router Kit WLAN / LTE
5.1 Preparing the hardware
Requirements
All components are installed as described under "Installing the Router Kit WLAN / LTE in the
installation enclosure (page 11)".
Procedure
34. Insert the SIM card into the LTE module (SCALANCE M876-4).
35. Attach the LAN cable between the LTE module and a PC with adapter.
36. Supply the Router Kit with a voltage of 230 V AC (SITOP PSU100C).
5.2 Setting up interfaces
Download of PST (Primary Setup Tool)
You can find the download on the Internet
(https://support.industry.siemens.com/cs/ww/en/view/19440762).
Requirements
● The IP addresses to be assigned must be in the same address range as the IP address
of the LTE module (default IP of the LTE module is 192.168.1.1).
● You require administrator rights to download the PST.
● You need a ready-for-use LAN adapter to set the IP address.