Siemens SIMOTICS CONNECT 400 Manual

6 Commissioning the Router Kit WLAN / LAN
6.3 Setting up interfaces
Application example for SIMOTICS CONNECT 400 - Router KitInbetriebnahme- und Montagehandbuch 71
6.3 Setting up interfaces
Download of PST (Primary Setup Tool)
You can find the download on the Internet
(https://support.industry.siemens.com/cs/ww/en/view/19440762).
Requirements
● The IP addresses to be assigned must be in the same address range as the IP address
of the LTE module (default IP of the LTE module is 192.168.1.1).
● You require administrator rights to download the PST.
● You need a ready-for-use LAN adapter to set the IP address.
Setting the correct interface from a Windows 7 PC to the modules
99. To open the "Network and Sharing Center", right-click on the WLAN symbol in the taskbar
and select the command "Open Network and Sharing Center".
Figure 6-12 Opening the Network and Sharing Center
100. Select the "Change adapter settings" option.

Siemens SIMOTICS CONNECT 400 Specifications

General

Brand	Siemens
Model	SIMOTICS CONNECT 400
Category	Control Unit
Language	English