Siemens SIMOTICS CONNECT 400 - Page 133

Procedure
NOTICE
Damage to the connectivity module by disconnecting the battery
If the battery is disconnected while the 󹪝rmware is being updated, this can result in irreparable
damage to the connectivity module.
Do not disconnect the battery while the 󹪝rmware is being updated.
1. Activate the Wi-Fi on your mobile device.
2. Open the "SIDRIVE IQ Con󹪝g" application.
3. If successful onboarding to the SIDRIVE IQ Fleet has already been performed with the
connectivity module, 󹪝rst perform the basic function "Send data to MindSphere" (Page 135).
This is necessary to avoid loss of data. Then continue with the following steps.
4. In the dashboard view, under "Commissioning settings", select function "Firmware".
5. Tap on the "Update" button. The Android File Picker opens.
Maintenance
8.1Updating the software and 󹪝rmware (Android)
SIMOTICS CONNECT 400
Operating Instructions, 04/2023, A5E50161952B AL 131