Siemens SIMOTICS CONNECT 400 User Manual

FCC Declaration of Conformity
This equipment complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions:
(1) This device may not cause harmful interference.
(2) This device must accept any interference received, including interference that may cause un‐
desired operation.
Any changes or modi󹪝cations made to this equipment that are not expressly approved by SIEMENS
could void the FCC authority to operate this device.
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful inter‐
ference to radio or television reception, which can be determined by turning the equipment o󹪜 and
on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the distance between the device and receiver.
• Connect the equipment into an outlet on a circuit di󹪜erent from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV technician for help.
Declaration on radio frequency exposure
This equipment complies with the radio frequency exposure limits of the FCC in an uncontrolled
environment.
This equipment must be installed and operated at a minimum distance of 20 cm between the device
and users or bystanders.
This equipment must not be co-located or operated in conjunction with any other antenna or
transmitter.
Further information
10.4Directives and standards
SIMOTICS CONNECT 400
210 Operating Instructions, 04/2023, A5E50161952B AL

Siemens SIMOTICS CONNECT 400 Specifications

General

Brand	Siemens
Model	SIMOTICS CONNECT 400
Category	Control Unit
Language	English